Tile edging machine will encounter some common problems when processing ceramic tiles. The water level is not flat. It is possible that after the machine has been used for a period of time, the ground may be soft due to the long time working in the water. Therefore, the horizontal plane is not flat, or the sturdy cement foundation is not installed when the tile edging machine is installed, so that the self-weight of the main body itself cannot be withstood, and the machine sinks, resulting in unevenness. The solution is to fill the foundation and level the fuselage.

       The tile bracket feet are not fixed. It is easy to shift when grinding large tiles, resulting in differences in levels. Solution, you need to correct the bracket. Long-term use of the machine only replaces a small part of the conveyor chain block glue, the new and old block glue used together, the height is different, resulting in the polished tile has a size head. Solution, replace all the glue or simply replace the entire conveyor chain.

       The conveyor chain causes uneven levels. The conveyor chain and the front conveyor belt are not in a straight line (not horizontal). To solve the problem, first adjust the height of the guide rail at the end of the tile (can be realized by adjusting the stroke screw screw under the guide rail), so that the tile can be transported on the conveyor chain of the guide rail from the beginning to the end when grinding, if it is not necessary Raise the rail travel screw until it is flat. The conveyor chain adjustment level on the left side of the machine is also reasoned according to this principle.

      The head and tail or the middle cannot be polished, and the sprocket of the bone row is displaced after the end of the tile, causing the tile to shift when it advances. To solve the problem, first disassemble the two sets of hoods and correct the height and angle of the two sprocket wheels on the out of the tile. The two sprocket wheels on the gearbox are the same. The middle can not be polished or polished well, the front and rear platens are too loose, and the tiles sink in the grinding process, resulting in too much grinding in the middle of the tile, so that the middle can not be polished or under-polished. Solution, remove the boot shell and fasten the splint chain.